- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Jawbone Charge Indicator Stays Red for hours
[ Edited ]10-23-2009 01:03 AM - last edited on 10-23-2009 01:05 AM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
Hi,
My Jawbone Prime charge indicator stays on red for
way past 50 minutes. I had it on 2-3 hours the last two
times. it didn't seem to chage to white until I disconnected
it and reconnected nad left it on charge awhile.
The connection seem weird as I have to plug in on
and remove it a few times to get it to connect to light
up red.
I've had it on 5 hours tonight and reconnected for a half
hour now and it's still red. It seemed the after a charge
was seccessful in the past it would then charge fast
if I hadn't let it run down much.
Now I see it has turned white after I reconnected
it again and left it about 15 minutes.
Is it charging when it's red and not turning on the white
indicator? I could see this being a hassle when I go
to using my car charger more when our new law
here goes into effect.
I purchased it on Ebay factory sealed.
It may be grey area so I purchased an
Ebay 3 year SquareTrade warranty on
the Jawbone Prime.
Can Jawbone replace it for me before I go to
SquareTrade. They say they try to get the manufactuer
to do so during the 1st year but will do it of the
manufacturer will not.
I'm just hoping Jawbone will see my post and be
nice since I had the SquareTrade and Ebay
receipt.
Or do you have some advice in why this is happening
and how I can test or work around it. I do have a
car charger with it's own USB charge cable. I think
I noticed the weak connection on it also. I will try
it.

